VIDEO: FUNNY BLOW OFF VALVE SOUNDS

First off, if you don’t own a turbocharged car, enjoy the videos of our SXdrv.com models, then turn the page. But if you’re honestly driving around a STI, Evo or GTI, or perhaps you’ve thought about turbocharging your Civic or Z, keep reading because you’re going to want to invest in a good blow-off valve.

The underlying objective of a blow-off valve (BOV) is to protect the turbo against damage while ensuring smooth and reliable drivability. It just so happens it makes a loud sound that gets every ones attention! But the noise it makes shouldn’t be what you’re most concerned about; you have to make sure you have the right valve for your ride that’ll keep your turbo happy and healthy.

Compressor Surge

Every component of a turbo system needs to work together. But when there’s compressor surge, it can create headaches, mess with performance and even cause damage to your precious car. Compressor surge occurs when you suddenly lift off the gas pedal and the throttle plate closes. A rush of boost heads into the engine and when it hits the closed throttle plate, it has nowhere to go but back into the turbo.

The effect of this boost backtracking into the compressor outlet and interfering with the compressor wheel is called compressor surge. Now, why is it bad? As the boost returns to the compressor wheel, it can slow or stall the wheel putting stress on the wheel shaft and bearings. Not only damaging, this surge can also mess with turbo response and kill drivability. The wheel loses its momentum and also creates lag, but man does it sound good! Chewchoochoochoo. A good blow-off valve can come to the rescue and keep the surge out of the turbo by venting it to the atmosphere. Pssshhhh!

Blow-off Basics
Here’s how it works… A blow-off valve is connected to the intake tract. Inside the valve’s main housing is a vacuum chamber with a spring, a diaphragm and valve. The diaphragm reacts to pressure changes and at a predetermined vacuum it’s pulled toward the vacuum source, compressing the spring inside the housing. The spring is connected to a valve that pulls away from its seat and releases the unwanted boost pressure.

On some BOVs, an adjustment screw lets you control at what pressure in the intake system the valve is activated. You can also swap the spring to change the activation point.
Blow-off valves are often referred to by diameter, 40mm being a common size. Picking the best valve comes down to the how much boost you’ll be running and the physical space available for installation.

When to Bypass

Not all turbocharged engines are made for blow-off valves, they might need a bypass (aka diverter or recirculating) valve instead. They both accomplish the same task but there’s a big difference in how they do it.

The type of engine management your car runs will come into play when choosing a valve. If you have a MAF-type system, it meters the airflow after it enters the intake system. In this case, when a blow-off discharges to the atmosphere, the ECU isn’t able to properly fuel the engine resulting in rich AFRs, hesitation, bad idle and even stalling. In these systems, the excess pressure must be plumbed back into the turbo system before the compressor inlet, which is what a bypass valve does.

Remember, the key to picking a valve is to know your car and what kind of plumbing it needs. But if you know what you’re doing, here are our top picks for BOVs you should check out. They all come from reputable companies and they also offer a wide range of applications. Hit them up if you have questions but just don’t be “that guy” and ask about what noise it makes…

And this is what happens when turbo enthusiasts have a sense of humour...